Project experience · Assembly & packing

A Matched Geared Servo Package, from Interfaces to Packing

A rotary-positioning project needed the mechanical and electrical pieces to arrive as a defined package. The work connected motor and gearbox interfaces with holding brakes, external drive hardware, matching harnesses and integration documents.

Component matching, assembly coordination and documentation were brought together through our motion-supply work. This example follows the assembled and packed scope.

Assembled geared servo motor and coiled power, feedback and brake harness on the project workbench

Project-specific assembly and matching harness during shipment preparation.

Project assembly and packing photographs.

3

Actuator sets

2

Gearbox ratios: 30:1 and 8:1

4

Inner cartons in one crate

The engineering task

Match two positioning directions to a common drive platform

The package used a common nominal-48V servo platform with two planetary-gear configurations. A higher reduction addressed the loaded-positioning and holding-duty review; a lower reduction addressed the higher-speed positioning direction. The mounting faces, shaft interfaces and cabinet connections had to be considered with the motor and gearbox selection.

Mechanical mating

The component interfaces were organized into assembled motor, adapter and gearbox units. Drawings and external-envelope STEP references supported the mounting and installation review.

Electrical package scope

Separate servo drives, braking units and resistors were matched with power, feedback and brake wiring. Harness and relay arrangements connected the assemblies to the cabinet hardware.

Coordinate the parts that cross supplier interfaces

  1. 1

    Define the package

    Connect positioning duty, nominal DC power, mounting and holding requirements to the component review.

  2. 2

    Review the mechanical interfaces

    Match the motor, gearbox and adapter interfaces; prepare the configuration envelope and installation references.

  3. 3

    Prepare the harness and cabinet kit

    Organize power, position-feedback, brake and I/O wiring alongside the external CANopen drives and electrical braking hardware.

  4. 4

    Organize the documents

    Bring the configuration datasheet, external-envelope CAD and wiring/communication references together for integration.

  5. 5

    Assemble and pack

    Prepare three actuator sets with their harnesses and a separate electronics carton within the crated shipment.

Packing and handoff

Keep the actuator sets and cabinet components identifiable

Three inner cartons held the actuator sets and attached harnesses. A fourth carton held the separate drive/braking components and tuning accessories. The packing list connected these items to the configuration and integration documents.

Four closed inner cartons arranged inside an open plywood shipment crate

Project-specific packing: three actuator cartons and a separate electronics carton.

Project assembly and packing photographs.

Carry the configuration into the documentation

Mechanical references

External-envelope STEP and interface drawings for the selected assembly.

Package records

Configuration datasheet, component list and carton-level packing scope.

Integration references

Wiring, drive communication and configuration information for the agreed hardware.

For a similar package, agree the operating conditions and acceptance work alongside the build revision. Configuration CAD and documents are supplied for the assembly under review.

Geared-servo package questions

What does this project example cover?

The example covers two geared-servo configurations and three actuator sets, with mechanical mating, matched harnesses, external drive and braking hardware, configuration documents and four-carton crated packing.

Can we order a package for a different rotary axis?

Yes. Begin with the shaft duty, load inertia, installation envelope, DC power capability and controller interface. Use the reference assemblies to identify what can stay standard and what needs an interface or component review.

Which project documents are relevant to our enquiry?

Request the configuration datasheet, mounting and external-envelope CAD, component list and wiring/communication references appropriate to the selected package. The scope and revision are agreed for your project.

Your next rotary axis

Bring the load cycle and the interfaces you need to match

Send output torque and speed, duty and inertia, the mounting envelope, DC supply and current capability, controller interface and quantity. Mark open questions so the first review can focus on the decisions that shape the package.